The Autotune connects to the Dynatek Fusion with a single cable and requires only a ground and +12 volt connection to be made to install. If your exhaust does not already have an 18mm O2 sensor, a weld in O2 sensor bung is included. Once installed, the Autotune kit monitors the fuel mixture (by installing the included Wide Band O2 sensor in the exhaust). It then sends this information to the Dynatek Fusion and automatically corrects it while you ride. Each map offered has preset air/fuel ratio values included that have been found to be the best overall settings. This lets you simply plug in the unit and let it do the work. For advanced users that would like to change the air/fuel ratios from our baseline they are fully adjustable. Each throttle opening/rpm combination is individually adjustable, so that you can have both fuel economy, during cruise, while maintaining peak output at larger throttle openings. For most models of bikes it is also possible to adjust the Air/Fuel ratios “per gear”. This gives you total control of the fueling in every gear and throttle/rpm area if required.
The single channel Autotune includes 1 O2 sensor (18mm) and works with 1, 2 (non V-twin), 3 and 4 cylinder or single O2 sensor equipped motorcycles
The Dual channel Autotune includes 2 O2 sensors (18mm) and works with metric V-Twin or dual O2 sensor equipped motorcycles
Dynatek Fusion controller is required for use with the Dynatek Autotune
NOTE: Not legal for use in California on pollution controlled vehicles, race use only in California - waiver available.
